 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| TFS433P.doc Version 1.1 05.03.2003 VI TELEFILTER Measurement condition Ambient temperature: 23 C Input power level: 0 dBm Terminating impedances*: input: 190 output: 190 Filter Specification TFS 433P 1/5 // -3,40 pF // -3,40 pF Characteristics Remark: Reference level for the relative attenuation arel of the TFS 433P is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae . The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss a e. The nominal frequency fN is fixed at 433,92 MHz without tolerance. The given values for the relative attenuation arel have to be reached at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data Insertion loss (Reference level) Nominal frequency Centre frequency 2 dB bandwidth 3 dB bandwidth 6 dB bandwidth Relative attenuation fN .... fN 200 kHz fN 200,0 kHz .... fN 220,0 kHz fN 220,0 kHz .... fN 280,0 kHz fN - 1,0 MHz .... fN - 5,92 MHz 16,5 fN - 5,92 MHz .... fN - 19,92 MHz fN - 19,92 MHz .... fN - 423,92 MHz fN + 1,0 MHz .... fN + 8,0 MHz fN + 116,08 MHz .... fN + 566,0 MHz Temperature coefficient of the frequency Frequency inversion temperature Operating temperature range Storage temperature range Input power level arel fN fc ae = amin typ. value 2,60 dB Variation/ Limitation max 3,5 dB 433,92 700,0 800,0 955,0 dB 42,0 55,0 14,0 60,0 MHz kHz kHz kHz min min min max max max 15,0 min min min min 2 433,92 MHz 400 440 560 2,0 3,0 6,0 dB 40,0 45,0 10,0 45,0 kHz kHz kHz dB dB dB dB dB dB dB min dB dB dB dB ppm/K C TCf**) To) -0,040 10 - 25 C ... + 80 C - 45 C ... + 120 C max 10,0 dBm *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) fc(Hz) = Tcf(ppm/K) x (To - TA) x fCAT (MHz) Generated : Checked / approved : TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information TFS433P.doc Version 1.1 05.03.2003 VI TELEFILTER Construction, pin configuration and 50 (All dimensions in mm) Filter Specification - matching network TFS 433P 2/5 7 5 1,78 433P R10 1 3 SQ 3,81 + 0,2 / -0,1 1,78 0,6 0,1 Date code 1,2 Max. 2,54 Pin Pin Pin Pin 1 2 3 4 Ground Input Ground Package Ground Pin 5 Pin 6 Pin 7 Pin 8 Output Ground Ground Package ground Date code: N P R ... Year + week 2001 2002 2003 50 Ohm Test circuit L1 2 Input 50 Ohm C1 2 5 L2 Output C2 50 Ohm SAW 1,3,4,6,7,8 TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information TFS433P.doc Version 1.1 05.03.2003 VI TELEFILTER Stability Characteristics Filter Specification TFS 433P 3/5 After the following tests the filter shall meet the whole specification: 1. Shock: 2. Vibration: 3. Change of temperature: 4. Resistance to solder heat (reflow): 4; 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 -55 C to 125C / 30 min. each / 10 cycles DIN IEC 68 part 2 - 14 Test N reflow possible: twice max.; for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page Packing Tape & Reel: IEC 286 - 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer 3000 min 300 mm min 500 mm min 300 mm Tape (all dimensions in mm) W : 12 0,3 Po : 4 0,1 Do : 1,5 + 0,1 E : 1,75 0,1 F : 5,5 0,05 G (min) : 0,75 P2 : 2 0,05 P1 : 8 0,1 D1(min) : 1,5 Ao : 4,3 0,1 Bo : 4,3 0,1 CT : 9,5 0,1 Po EMBOSSED CARRIER TAPE Do P2 E Ao F W D1 CT Bo G P1 COVER TAPE W2 Reel (all dimensions in mm): A W1 : : 330 12,4 + 2,0 18,4 50 13 -+0,5/ -0,2 A C N W2 (max) : N (min) C : : W1 The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape. Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right. TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information TFS433P.doc Version 1.1 05.03.2003 VI TELEFILTER Air reflow temperature conditions Filter Specification TFS 433P 4/5 1st and 2nd air reflow profile Name: Temperature: Time: pre-heating periods 150 C - 170 C 60 sec. - 90 sec. main-heating periods over 200 C 20 sec. - 25 sec. peak temperature 255 C 5 C Chip-mount air reflow profile 260 240 220 200 180 temperature / C 160 140 120 100 80 60 40 20 0 0 20 40 60 80 100 120 time / sec. 140 160 180 200 220 240 Table for temperature vs. time during the air reflow process Tolerance of temperatures: 5 C time / sec. 0 10 20 30 40 50 60 70 80 90 100 110 120 130 temperature / C 23 34 46 60 80 103 121 134 143 150 154 156 158 159 time / sec. 140 150 160 170 180 190 195 200 205 210 215 220 230 240 temperature / C 160 161 164 170 180 205 230 255 230 205 180 165 140 120 TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information TFS433P.doc Version 1.1 05.03.2003 VI TELEFILTER History Version 1.0 1.1 Reason of Changes Filter Specification TFS 433P 5/5 Name Dr. Sabah Date 11.12.2001 - Generation of development specification according to customer specification - Filter specification, add of typical values, terminating impedance and change of package high Dr. Sabah 05.03.2003 TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information |
Price & Availability of TFS433P
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |